In this modern world, fiber optics are gaining more and more popularity among the communication networks. They’re trusted in every kind of communication nowadays this special kind of cables are the back bone of each and every known network whether it’s telecommunication or live broadcasting Television channels. When bulk data transfer is needed then top end fiber communication is considered as the best choice. Nowadays of fiber data is transferred in the form of light pulses. It was small introduction, now we come towards fiber optic patch cables.

Fiber optic patch cable is a two-fiber cable that uses exactly the same connector type and optical fiber type because the optical fiber cabling that it is connected to. Sometimes we aslo refer to it as a fiber optic jumper. The terms fiber optic patch cable and fiber optic jumper are often interchanged but as it happens they are different. An area cable is really a two-fiber cable, however the term fiber optic jumper is usually used to describe a single-fiber cable.

Fiber jumper is defined in IEEE 802.3 as an optical jumper cable assembly used for bidirectional transmission and reception of information. A fiber jumper can be a single-fiber cable or a multi-fiber cable. The jumper cable attached to the source of light is known as the transmitter jumper. The fiber jumper cable attached to the fiber optic power meter is known as the receiver jumper. But you may also see these test fiber jumpers referred to as a reference jumper. However they are named, fiber jumpers are a critical a part of your fiber optic test equipment setup.

Fiber patch cables are like joints, these are used to join 2 kinds of optic cables in order to make a third connection out. The first thing that is most important, while choosing the patch cable is the compatibility of those patch cables with the original cable. When you purchase the wrong cable then, it won’t work. Second thing may be the rate of information transfer. Different types of these cables have different data transfer rate and when you need to join them through patch cables then you need to make sure that the information rate of patch cables should match the information rate of original cable if this doesn’t match then, you will see a lag in communication which could cause a delay or total loss of information.

There are some other advantages too. For instance they offer a very high-speed of information transfer. Fiber optic cables are made to possess a little more speed than usual fiber cables to complement what’s needed when they are adjusted towards the network. Another factor that is higher in such cables is band width. These offer a high bandwidth than normal fiber optic cables. Last but not the least is the security factor. These patches are made very secure to operate at any level which is nearly impossible to interrupt into them.

These are the best answer for your home communication needs. Whether you’ll need a high speed internet connection or else you wish to connect your TV with a satellite antenna. These patch cables would be best since you just need to bring them and fasten them with any place in the fiber network and they’ll fulfill all your needs. So I we do hope you will consider fiber patch cables for your home communication needs after reading a lot of advantages and also because I have installed them inside my own home. They’re little expensive but that comes with quality.

Source: http://www.fiberstore.com/